Panasonic WV-SP105

30
30
31
Configure the multi-screen settings [Multi-screen]
The cameras from which images are to be displayed on a multi-screen can be registered on the "Multi-screen"
page. (☞Pages13and14:Howtodisplay/operatethesetupmenu)
[IP address]
Enter the IP address or the host name of the camera to
be used for the multi-screen. 4 cameras can be regis-
tered as a group and up to 4 groups (16 cameras) can
be registered.
When the HTTP port number for the camera of which
images are to be displayed had been changed, enter as
follows:
Example of entry:
ExamplewhenenteringanIPv4address:
192.168.0.10:8080
ExamplewhenenteringanIPv6address:
[2001:db8:0:0:0:0:0:1]:8080
Available number of characters: 1 - 128 characters
Note:
 • Whenusingthehostname,itisnecessarytocon-
figure the DNS settings of the PC to be used for the
multi-screen display.
[Camera title]
Enter the title of the camera. The entered camera title
will be displayed on a multi-screen.
Available number of characters: 0 - 20 characters
Note:
 • Whenselectinga16split-screen,somecharacters
of the camera title to be displayed may not be dis-
played.
 • Evenwhen"16:9"isselectedfor"Aspectratio",the
multi-screenisdisplayedin4:3.