Panasonic WV-SP105

40
40
41
Configure the settings of the servers [Server]
The settings relating to the mail server, the FTP server and the NTP server can be configured on this page.
The"Server"pagehas3tabs;the[Mail]tab,the[FTP]tabandthe[NTP]tab.
Configure the settings relating to the mail server [Mail]
Click the [Mail] tab on the "Server" page. (☞Pages13and14:Howtodisplay/operatethesetupmenu)
The settings relating to the mail server used to send the alarm mail can be configured on this page.
Important:
 • Whenaterminalthatreceivese-mailsisnotcompatiblewithUTF-8encode,itisimpossibletoreceivealarm
mails correctly.
[SMTP server address]
Enter the IP address or the host name of the SMTP
server used to send e-mails.
Available number of characters: 1 - 128 characters
[SMTP port]
Enter the port number to which e-mails are sent.
Refer to the help window to infomation about the
unavailable port number.
Availableportnumber:1-65535
Default: 25
[POP server address]
When"POPbeforeSMTP"isselectedfor"Type",enter
theIPaddressorthehostnameofthePOPserver.
Available number of characters: 1 - 128 characters
Important:
 • Whenenteringthehostnamefor"SMTPserver
address"or"POPserveraddress",itisnecessaryto
configure the DNS settings on the [Network] tab of
the "Network" page. (☞ Page 45)
[Type]
Select the authentication method to send e-mails from
the following.
None: It is not necessary to clear any authentication to
send e-mails.
POP before SMTP: It is necessary to first clear the
POPserverauthenticationtousetheSMTPserver
to send e-mails.
SMTP: It is necessary to clear the SMTP server authen-
tication to send e-mails.
Default: None
Note:
 • Whenyoudon'tknowtheauthenticationmethodto
send e-mails, refer to the network administrator.
[User name]
Enter the user name to access the server.
Available number of characters: 0 - 32 characters
[Password]
Enter the password to access the server.
Available number of characters: 0 - 32 characters
[Sender's mail address]
Enter the mail address of a sender.
The entered mail address will be displayed in the
"From" (sender) line of the sent mails.
Available number of characters: 3 - 128 characters