Panasonic WV-SP509

14
Precautions for Installation
This camera is designed to be used
indoors.
This camera is not operable outdoors.
Do not expose this camera to direct sunlight for
hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion. Keep this camera away from water and
moisture.
Installation place
Contact your dealer for assistance if you are
unsure of an appropriate place in your particu-
lar environment.
 • Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
 • Installthecamerainthefoundationareaof
the architecture or where sufficient strength
is assured.
 • If aceiling boardsuch as plasterboardis
too weak to support the total weight, the
area shall be sufficiently reinforced.
Do not place the unit in the following places:
 • Locations where it may get wet from rain
or water splash
 • Locationswhereachemicalagentisused
such as a swimming pool
 • Locationssubjecttomoistureoroilsmoke
such as a kitchen
 • Locationsthathaveaspecificenvironment
that is subject to an inflammable atmo-
sphere or solvents
 • Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
 • Locations where corrosive gas is pro-
duced, Locations where it may be dam-
aged by briny air such as seashores
 • Locations where the temperature is not
within the specified range (page 35).
 • Locations subjecttovibrations(Thisprod-
uct is not designed for on-vehicle use.)
 • Locations subject to condensation as the
result of severe changes in temperature
Be sure to remove this product if it is not
in use.
Shielded (STP) LAN cables must be used
with this unit to ensure compliance with
EMC standards. *
* E models only
Before installation
 • When this camera and camera mount
bracket are mounted on a ceiling or a wall,
use the screws described on page 23. The
screws to be used are not provided.
Prepare the screws according to the mate-
rial, structure, strength and other factors of
the mounting area and the total weight of
objects to be mounted.
 • Ensure that the mounting surface, anchor
and screws are sufficiently strong.
 • Do not mount this product on a plaster
board or a wooden section because they
are too weak. If this product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
About the network connection
When connecting to a network using the net-
work cable of this product, observe the follow-
ing.
 • When wiring for the network, design and
engineer not to be affected by thunder.
Panasonic assumes no responsibility for injuries or property damage resulting from fail-
ures arising out of improper installation or operation inconsistent with this documenta-
tion.