Panasonic WV-SP509

17
<Rear view>
About the [INITIAL SET] button
After turning off the power of the camera, turn on the power of the camera while holding down this
button, and wait for around 5 seconds or more without releasing this button. Wait around 2 minutes
after releasing the button. The camera will start up and the settings including the network settings
will be initialized. Do not turn off the power of the camera during the process of the initialization.
Before initializing the settings, it is recommended to write down the settings in advance.
POWER
10BASE T/100BASE-TX
AUDIO OUT MIC/LINE IN
EXT I/O
SD CARD/ABF
MONITOR OUT
ACTLINK
12V = IN
GND 4 3 2 1
INITIAL
SET
ALARM IN 1/DAY/NIGHT IN
ALARM IN 3/AUX OUT ALARM IN 2/ALARM OUT
12 V DC power supply terminal
Monitor for adjustment
Output connector
Power indicator
Access indicator
(blinks when accessing)
Link indicator
Network connector
Audio output connector
EXT I/O terminals
INITIAL SET button
Microphone/line input connector
(lit when linking)
SD memory card error indicator/
ABF indicator (blinks when ABF is being
activated)
POWER
10BASE T/100BASE-TX
EXT I/O
ABF
MONITOR OUT
ACTLINK
12V = IN
GND 4 3 2 1
INITIAL
SET
ALARM IN
AUX OUT ALARM OUT
12 V DC power supply terminal
Monitor for adjustment
Output connector
Power indicator
Access indicator
(blinks when accessing)
Link indicator
Network connector
EXT I/O terminals
INITIAL SET button
(lit when linking)
ABF indicator
(blinks when ABF is being activated)
<WV-SP509>
<WV-SP508>