Panasonic WV-SP509

21
Installation
Connect the safety wire
The following is an example of safety wire connection.
IMPORTANT:
 • Besuretoinstallthesafetywire.Askyourdealerforinstallation.
For mounting on ceiling
z Remove the tripod mount base on the top
of the camera.
x Align the tripod mount base with the safety
wire plate for ceiling (accessory) and attach
them to the camera with the mounting
screws.
IMPORTANT:
 • Use the detached mounting screws to attach the tripod mount base. When using different
length screws, it may damage the camera or cause the camera to fall.
(Recommended tightening torque: 0.39 N·m {0.29 lbf·ft})
c Engage the safety wires with the wire engaging holes respectively.
T
Mounting screws
Tripod mount
base
Safety wire plate
for ceiling
(accessory)
Wire engaging hole
Pass the ring part of the safety wire
through the wire engaging hole.
Wire engaging hole
Safety wire
(accessory)