QUICK START WITH THE Viper™ LS6
9
1. Plug in the AC adapter.
2. Install a ribbon cartridge. See Section-Ribbon Cartridge Installation
page 9. NOTE: No ribbon required for Thermal Paper
3. Install a label cartridge – See Section – Label Loading (Page 11) OR
install included thermal paper sample cartridge (1” wide practice media).
4. Turn ON the printer. Press . If low battery message, select [N] to
continue. The following screen will appear:
5. Press [D] for Demonstration. Press at any time to exit.
6. Read Demonstration screens to understand printer operation.
7. Press the button. The following tool selection screen will appear:
8. Select the Icon or press [T] to select a Text Tool.
9. Type in up to 4 lines of up to 16 characters. Example: “PANDUIT”
10. When complete, press the key to return to the HOME Screen.
11. Press the key to print your label.
To Next Page
Loading...
Need help?
General