12 User’s Guide
Table 1: User Code Sections
How do I program access codes?
1. Press [ENTER].
2. Enter your [
MASTER CODE].
[ENTER] button flashes.
3. Enter 3-digit [SECTION] (see Table 1 on page 12).
The [NUMBER] corresponding to the first digit of the existing
code (if programmed) and the [
ENTER] button will illuminate
(see Appendix A
on page 35).
4. Enter a new 4 or 6-digit [ACCESS CODE].
[ENTER] button flashes. Return to step 3 to enter next code or
press [
CLEAR] to exit.
How do I delete access codes?
1. Repeat steps 1 to 3 (see above).
2. Press the
[FORCE] button once for each digit in the access
code (4 or 6 times) until the keypad emits a confirmation
beep then press the [
CLEAR] button to exit.
Do not delete the System Master Code. Refer to the warning
in section 3.1 on page 10 for more information.
Section User Codes
[001] User Code 001 = System Master Code
[002] User Code 002 = Master Code 1
[003] User Code 003 = Master Code 2
[004] to [047] User Code 004 to User Code 047
[048] User Code 048 or Duress Code
To Next Page
Loading...
