Spectra LED Keypads 23
simultaneously pressing and holding two specific buttons for
two seconds. Based on your needs, these panic alarms can
generate audible alarms (sirens or bells) or silent alarms,
both of which can send a message to your monitoring
station. The three different panic alarms can communicate
specific messages to your monitoring station. For instance,
pressing [1] & [3] can mean “call the police” or anything you
require. Your installer must enable this feature.
1. Press & hold buttons [1] and [3] for the police.
2. Press & hold buttons [4] and [6] for a medical alarm.
3. Press & hold buttons [7] and [9] for a fire alarm.
5.4 Programming the Clock
5.5 PGM Button (Programmable Outputs)
Your Spectra system may include one or more
programmable outputs (PGMs). When a specific event or
condition occurs in the system, the PGM can be used to
reset smoke detectors, activate light switches in your home
or office, open/close garage doors and much more. A PGM
can also be programmed to activate whenever the [
PG]
button is pressed and held for 3 seconds.
How do I program the System Clock?
1. Press the [ENTER] button.
2. Enter [
MASTER CODE].
[ENTER] button flashes.
3. Enter [100] (see Appendix A on page 35).
4. Enter the desired
[TIME].
Example: 6:15 p.m. = 18:15
To Next Page
Loading...
Need help?
General
