14 User’s Guide
4.3 Regular Arming
This method, commonly used for day-to-day arming, will
arm all the zones in the selected partition.
When you have correctly armed the system, the
ARM light
corresponding to the armed partition will turn on and the
Exit Delay (see page 13) will initiate. Please note that
Regular arming can also be activated using Auto-Arming
(see page 21), a keyswitch (see page 20), or One-Touch
arming (see page 19).
How do I disarm the system?
For a Stay or Instant armed system, go to step 2.
1. Enter through a designated entry point (i.e. front door).
The keypad will beep during the Entry Delay.
2. Enter your [ACCESS CODE].
After the confirmation beep, the ARM light will turn OFF.
If you have access to both partitions (see page 9):
3. Buttons [1] and [2] will flash. Press the button
corresponding to the desired partition. For both partitions,
press the other button after the confirmation beep.
How do I Regular arm?
1. Close all zones in the desired partition.
2. Enter your [
ACCESS CODE].
If you have access to both partitions (see page 9):
3. Buttons [1] and [2] will flash. Press the button
corresponding to the desired partition. For both partitions,
press the other button after the confirmation beep.
To Next Page
Loading...
Need help?
General
