6 User’s Guide
Trouble List
[1] No or Low Battery Trouble
When the [1] button illuminates, the backup battery is
disconnected or the battery voltage is getting low.
[2] Wireless Transmitter Battery Low
When the [2] button illuminates, the battery voltage in one
or more wireless transmitters is getting low. Also, the
device’s yellow light will flash.
[3] Power Failure
When the [3] button illuminates, the system has detected a
loss of AC power. This trouble usually occurs during a
power failure. If a power failure is not occurring in your
establishment and this trouble appears, contact your
monitoring station for service.
[4] Bell/PGM2 Disconnected Trouble
When the [4] button illuminates, the bell, siren, or any
device connected to the PGM2 is no longer connected to
your alarm system.
[5] Bell Current Failure
During an alarm, the bell output, which uses a fuseless
circuit, will automatically shut down if the current exceeds
its limits. If this occurs, the [5] button will illuminate. When
the system is disarmed, the current is cut from the bell
output and the trouble warning may extinguish, but the
trouble may re-occur during the next alarm if the situation is
not corrected.
To Next Page
Loading...
Need help?
General
