Spectra LED Keypads 11
Master Code 2 is permanently assigned to Partition 2
(except when partitioning is disabled, Master Code 2 will be
assigned to Partition 1) and can be used to create, modify
or delete user access codes (see page 11) that are
assigned to the same partition.
Master Codes cannot modify or delete user access
codes assigned to both partitions. Only the System
Master Code can modify or delete user access
codes assigned to both partitions.
3.3 Duress Code
If you are forced to arm or disarm your system, entering the
Access Code assigned to User 048 will arm or disarm the
system and immediately transmit a silent alert (Duress
Code) to the monitoring station.
The Duress Code feature must be enabled by your
installer.
3.4 Programming Access Codes
Your system can use either 4- or 6-digit access codes (see
page 31), where each digit can be any value from 0 to 9.
Six-digit codes are considered more difficult to “crack” and
therefore, more secure. Avoid programming simple or
obvious access codes, such as your telephone number,
address or codes such as 1234.
To Next Page
Loading...
Need help?
General
