26 User’s Guide
6.0 Fire Alarms
In the event of a fire alarm, the bell/siren will emit three
“squawks” at 2-second intervals until silenced or reset by
entering a valid access code. If the zone is a Delayed Fire
Zone, there will be a delay before the system contacts the
monitoring station. This will prevent unnecessary reporting
of false alarms. If there is no fire condition, contact your
monitoring station immediately to avoid an unnecessary
response.
What do I do if a Delayed Fire Zone was set off
accidentally?
1. Press the [CLEAR] button within 30 seconds of the alarm.
2. Try to correct the problem.
3. If the problem persists, the alarm will sound again. Press
[
CLEAR] again.
These steps will instruct the system to delay reporting the fire
alarm to the monitoring station (see Figure 2 on page 27 for
details).
To Next Page
Loading...
Need help?
General
