18 User’s Guide
If you have access to both partitions, buttons [1] and
[2] will flash. Press the button corresponding to the
desired partition. The [BYP] button will flash and any
zones that are already bypassed will illuminate.
4.6.1 Bypass Recall Feature
After disarming the system, the bypass entries are erased.
The Bypass Recall Feature reinstates the previous bypass
entries saved in memory. There is no need to manually
reprogram bypass entries every time you arm the system.
How do I program bypass entries?
1. Press the [BYP] button.
2. Enter your [
ACCESS CODE] (see note below).
3. Illuminate the button(s) corresponding to the zone(s) you
wish to bypass by pressing the corresponding button.
Press the button again to turn it OFF. Press the [
FORCE]
button to erase all the current zone bypass entries.
4. Once you have entered the desired bypass entries, press
the [
ENTER] button to accept these entries.
The [
BYP] button will turn ON when zones are bypassed.
The next time the system is armed, the zones will be
bypassed.
How do I recall bypass entries?
1. Press the [BYP] button.
2. Enter your [
ACCESS CODE] (see note above).
3. Press the [
BYP] button.
4. Previously bypassed zones will illuminate.
5. Press the [
ENTER] button.
To Next Page
Loading...
Need help?
General
