Parker 512C - Potentiometers

4-3 Operating the Converter
512C Series Converter
Note:
*
8 Amp, 16 Amp and 32 Amp controllers can be scaled to currents of 4 Amp, 8 Amp or
16 Amp or less but it is recommended that lower current controllers be used in these
circumstances.
Current Motor Scaling
SW8
(OFF)
Current Meter
Buffered Current Meter Output
5V Equivalent to 100% of Controller Current Rating.
i.e. 4 Amp on 512C/04
8 Amp on 512C/08
16 Amp on 512C/16
32 Amp on 512C/32
SW8
(ON)
Current Meter
Buffered Current Meter Output
5V Equivalent to 100% of Calibrated Current Rating.
For Example 512C/16 SW5-ON,SW6-ON,SW7-OFF
Calibrated Current = 8 Amp therefore 5V = 8amp.
Potentiometers
P1
Ramp Up Rate
Rotate Clockwise for Faster Acceleration to Set
Speed.
Same
(Linear :- 1 to 40 seconds)
as 512
P2
Ramp Down Rate
Rotate Clockwise for Faster Deceleration to Set Speed.
Same
(Linear :- 1 to 40 seconds)
as 512
P3
Speed Loop Stability
Optimises Speed Loop Stability. ( Excessive
adjustment may lead to instability)
Same
as 512
P4
I Limit
Rotate Clockwise to increase Maximum Output
Current.
With no additional connection to Torque / Current
Limit Terminal T7, the Upper Limit is 110%. To
achieve the 150% maximum connect T7 to +7.5V.
Same
as 512
P5
IR Compensation
Optimises speed regulation against load change
when using Armature Voltage Feedback. Rotate
Clockwise to increase compensation and reduce
regulation.( Excess adjustment may lead to instability)
Turn Anti-clockwise when Tachogenerator Feedback
used.
Same
as 512
P6
Minimum Speed
Controls Minimum Motor Speed /Setpoint when
Speed Setpoint Potentiometer connected to Terminal
4. Rotate Clockwise to increase Minimum Speed /
Setpoint. (Approximately 30% adjustment when using
10K ohm Speed Setpoint Potentiometer.)
Same
as 512
P7
Maximum Speed
Controls Maximum Motor Speed. Rotate clockwise to
increase maximum speed.
Same
as 512
P8
Zero Speed Offset
Adjusts Zero or Minimum Speed for Zero Speed
Setpoint.
New
Feature
Table 4.3 Customer Adjustments.
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com