Cont.3
Requirements
IMPORTANT: Please read this information BEFORE installing the equipment.
Intended Users
This manual is to be made available to all persons who are required to install, configure or service equipment
described herein, or any other associated operation.
The information given is intended to highlight safety issues, EMC considerations, and to enable the user to obtain
maximum benefit from the equipment.
Complete the following table for future reference detailing how the unit is to be installed and used.
Serial Number
(see product label)
Where installed
(for your own
information)
Unit used as a:
(refer to Certification
for the Inverter)
Component Relevant Apparatus
Application Area
The equipment described is intended for industrial motor speed control utilising DC Shunt Wound or DC Permanent
Magnet Motors.
Personnel
Installation, operation and maintenance of the equipment should be carried out by qualified personnel. A qualified
person is someone who is technically competent and familiar with all safety information and established safety
practices; with the installation process, operation and maintenance of this equipment; and with all the hazards
involved.
Product Warnings
Caution
Risk of electric
shock
Caution
Refer to
documentation
Earth/Ground
Protective
Conductor
Terminal
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com
To Next Page
Loading...
Need help?
General
