The Keypad
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
Changing the Product Code (3-button reset)
On rare occasions it may be necessary to change the default settings by changing the Product Code. The
Product Code is detailed in Appendix E.
A special key combination is required to change the product code. This feature is only available at power-
up as a security measure.
The 3-button reset will take you to the POWER BOARD menu in the expanded SYSTEM menu
(highlighted in the diagrams below).
6901 Keypad Combination
Hold down the keys opposite:
-
Power-up the drive, continue
to hold for at least 2 seconds
t
E
PROG
HOLD
POWER BOARD
7.5kW 400V
for example
E
POWER BOARD
menu at level
*
*
*
Select from the
expanded SYSTEM menu
see
diagram
below
M
POWER BOARD
LANGUAGE
DEFAULT TO 60Hz
REFORMAT FLASH
RESET STO LOCK
890PX
RESTART
EXIT TO BOOT
LANGUAGE
MENU AT LEVEL 2
IMPORTANT We recommend the menus marked * above are only used by Parker SSD Drives or suitably qualified
personnel.
Note The LANGUAGE menu currently contains selection for ENGLISH only.
To Next Page
Loading...
