890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
POWER BOARD (6901 keypad)
s
E
PROG
HOLD
M
E
POWER BOARD
7.5kW 400V
POWER BOARD
????kW
POWER BOARD
????kW
POWER DATA
CORRUPT
E
E
WELCOME SCREEN
LANGUAGE
DEFAULTS LOADED
Hold down the keys opposite:
-
Power-up the drive, continue
to hold for at least 2 seconds
Config mode is selected,
indicated by all LEDs flashing
Config mode is de-selected-
LEDs cease flashing
The power data is stored
The diagram above shows a 3-button reset when there is no power data stored in the drive. If the drive has
power data stored, then the “Power Data Corrupt” and “Language Defaults Loaded” alert messages will not
be displayed, also the display will show the current power board selection, instead of “????kW ???V”.
You need to select 890PX if you have
890PX power boards, otherwise it will not
show the correct power ratings.
See “The Menu System Map”on page 9-40.
To Next Page
Loading...
