Parker ac890 - Page 354

Trips & Fault Finding
11-23
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
Alert Message IDs
ID Message Reason
6901 Keypad 6511 Keypad
33
NEW POWER DATA
DEFAULTS LOADED
CODE
Power board data on the control board does not match
that on the stack eeprom.
34
LANGUAGE
DEFAULTS LOADED
LANG Default language and frequency settings lost.
35
USING BACKUP
LANGUAGE
LANG Obsolete message
36
APPLICATION
NOT FOUND
DATA Attempt to save fixed parameter set before it is valid.
37
AUTOTUNE
IN PROGRESS
ATN
38 OPERATOR OPER
Alert displayed while changing to the operator menu
on pressing the PROG key.
39 DIAGNOSTIC DIAG
Alert displayed while changing to the diagnostic
menu on pressing the PROG key.
40 QUICK SETUP SET
Alert displayed while changing to the quick setup
menu on pressing the PROG key.
41 SETUP PAR
Alert displayed while changing to the setup menu on
pressing the PROG key.