Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA
17
Bulletin HY25-1650-M1/US
Installation Sketch
NOTES:
1) Reference Kits:
329255-12X
329601X
2) Caution: Torque Values must be Maintained 120-144 In-Lb
3) Strip Wire Ends 0.25" Prior to Installing Connector
Slice Grommet.
Insert in Hole in Clutch
Master Cylinder Seal
Assembly
Firewall Pass-Through Installation
379817 Grommet
Cut 1.00" Hole in Firewall
Near Ford Clutch Master
Cylinder Seal Assembly
The Clutch Master Cylinder Seal
Assembly is Located on the Engine
Compartment Firewall on the
Driver’s Side Near the Brake Master
Cylinder
Connector and 2-Wire
Shielded Cable
Run Cable through
Grommet in Firewall
Speed Sensor Extension Cable
328923-10X (10 Ft Supplied w/E.O.C.)
328923-5X (5 Ft Optional Cable)
(4.9")
(1.8")
Electronic Overspeed
Controller - 329650X
(1.0")
16 AWG Wire, Blue
16 AWG Wire, Green
Accepts 1/4" Screw
16 AWG Wire, Black
Connect to Ground
16 AWG Wire, Red
Connect per Wiring Chart
page 18
379243
Speed Sensor
28-P-171
O-Ring
Electrical Ground of Cab
3/8" Stud Size Ring Terminal
Connect to
Blue Wire from E.O.C.
Connect to
Green Wire
from E.O.C.
Blue Wire
Red Wire
See Wiring Chart page 18
329617X
Wire Harness
329232-1X
Hose Assembly
379502
Pressure Switch
2 See Torque Note
379698
90° Elbow
380089
Adapter
To 6R140 Transmission
High Pressure Port
RELAY
Electronic Over Speed Control (E.O.C.) Installation
Sketch for 248 Series (SK-489)
Owner’s Manual
Electronic Overspeed Control
To Next Page
Loading...
