Parker MIDIGAS 2 - Menu Interface and Settings

15
4.6 Menu Interface
The default menu displays the current operating status of the generator and, when running, indicates the purity of the gas delivered at the
“Nitrogen Outlet” port.
Note. The purity reading is for indication purposes only.
The menu driven interface provides access to the essential operational parameters of the generator. From the default menu use the and
keys to scroll through to the desired menu and press .
The interface will automatically default back to the main operating menu if no key activity has been detected for one minute. After an additional
two minutes of inactivity the display will shutdown. To bring the display back on-line press .
4.6.1 Menu Map
3.1 O2 Alarm
Over-ride = 0
3.2 O2 Calibration
= 5.00%
3.3 O2 Alarm Level
= 5.05%
3.4 O2 Alarm Delay
= 60s
3.5 Start Clean Up
Enable = 1
3.6 Economy Enable
= 1
3.7 Fault Relay
On Stop = 0
3.8 O2 Analogue FSD
= 6.00%
3.9 O2 PPM Offset
= [---]
3.10 Modbus Address
= 1
3.11 Remote Control
= 1
1. Hour Meters
2. Fault Log 2.1 Fault 1: Active
C1 at 5234h
2.1 Fault 10:
[---]
1.1 Hours Run
5234h
1.2 Service Due At
8000h
1.3 Hours Economy
25h
O2 = 5.00 %
Running
3. Customer
Settings