18
Mettler: PGS, PM, Viper Models P/N: 080-067PGS
Ohaus: GT, “Precision Advanced” P/N: 080-066
& “Explorer” & “Voyager” Models
Ohaus: IP Series High Capacity P/N: 080-067
Ohaus: Adventurer Pro Series P/N: 080-067PGS
Sartorius: Most Series Balances P/N: 080-068
In the FilterTec Plus Setup: Scale, Scale2 and Scale3, select the scale
manufacturer; the FilterTec Plus will automatically implement the correct
communications parameters. Check that the proper communications
parameters are also implemented in the scale you are using.
Pressure Sensor Ports: RJ11 Telephone jacks for the SciPres Disposable Pressure
Sensors, labeled “P1”, “P2”, and “P3”. The disposable pressure sensors plug into these
jacks using the included cables.
Temperature Probe Port: The SciTemp Disposable Temperature Senor connects to
this port with a twist-lock connector cable. Temperature is measured in degrees Celsius.
Valve V Port: Used in conjunction a 6-way Selector Valve (P/N: 080-510) in RP
Programmable Mode.
USB Port: Used for connection to a PC, providing a Com Port. Can be used for data
collection as an alternative to the Printer port. The driver is included on the CD that
contains this manual.
Ethernet Port: Used for connection to the FilterTec Plus via a LAN. IP Address, Subnet
Mask, and Gateway are configured in the Setup menu. The communication protocol is
Modbus TCP/IP, and a list of registers is in the appendix of this manual. (When
available.)
To Next Page
Loading...
Need help?
General
