Thermostat
1. Remove the thermostat cover and thermostat.
2. Hang the thermostat in a container with water.
3. Heat the container.
4. Check the valve open height under the specified water temperatures. If out of order, change it.
Water temperature Valve open height
Under 62℃ 0.1mm
Over 70℃ Over 3mm
5. Fit on the thermostat and thermostat cover, then tighten the screws to specification.
RECOIL STARTER
NOTICE
When you service, always wear safety glasses and gloves. To prevent accidental start of the engine,
remove the spark plug cap and remove stopper hang rope from stop switch assembly.
22
To Next Page
Loading...
Need help?
General
