1.throttle cable stop screw
1
Idling speed
Check idling speed, and adjust it if necessary.
1. Preheat engine for 5 minutes.
2. Attach the tachometer to the spark plug wire to measure idling speed RPM. If out of
specification, adjust it.
Idling speed: 1450~1550 r/min
3. Turn the throttle stop screw clockwise or counter clockwise, until the specified idling speed is
attained.
NOTE:
Turning clockwise to increase idling speed.
Turning counter clockwise to decrease idling speed.
CAUTION:
Before adjusting the idling speed, the throttle cable slack should be properly adjusted. After
adjusting the idling speed, if necessary you can adjust the throttle cable again.
Start-in-gear protection
Set the shift lever in neutral, and check if the triangle marking of the detent aligns with the triangle
marking of the starter. If necessary, adjust the adjusting nut on the tightwire of the detent.
2
1
3
1. Triangle marking 2. Adjusting nut 3.Tightwire ass’y, detent
17
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General
