1. Use special tools when disassembling and assembling.
2. Clean dirt before disassembling the parts.
3. Oil the contact surfaces of moving parts before assembly.
4. Install bearing with the manufacturer’s markings on the side exposed to view and liberally
oil the bearing.
5. When installing oil seals, apply a light coating of water-resistant grease to the ledge and
outside diameter.
6. After assembly, check if the moving parts operate normally.
ONE-TIME USE PARTS
One-time use parts are gasket, oil seal, O-ring, cotter pin and spring, ring, and etc.. When
re-assembling outboard engine, you must change the one-time use parts.
PRE-DELIVERY CHECK
To ensure the using, please inspect the following before delivery.
1. CHECKING FUEL SYSTEM
Check if the fuel pipe is connected firmly, and if the fuel tank is filled with fuel.
CAUTION:
Do not use pre-mixed fuel for this 4-stoke outboard engine.
2. CHECKING OIL LEVEL
○
1 Check the engine oil level
Remove oil cap, check engine oil level.
1. Oil cap 2. Oil rule 3. High position mark 4. Low position mark
Ensure the oil level between
the marks of upper and lower. If above upper level, drain engine
oil; if below lower mark, add engine oil up to upper level.
○
2 Check the gear oil level
Remove the oil level plug. Check if the gear oil overflows at the oil level checking hole.
If so, install the oil level plug and tighten it according to specified torque.
Otherwise please add gear oil.
4
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General
