Cooling water passage inlet
2. Place the outboard engine in the water and ensure the water level is above the anti-vortex plate,
then start the engine.
3. Check if water overflows at the cooling water checking hole. If there is no flow or intermittent
flow, check the cooling water passage.
1. Cooling water inlet 2. Cooling water checking hole
2
RECOIL STARTER
NOTICE
When you service, please wear safety glasses and gloves. Please remove spark plug cap and
stopper hang rope from stop switch assy, in case of the accidental start of the engine.
20
https://www.boat-manuals.com/
To Next Page
Loading...
