Partlow MIC 2000 - Page 4

PAGE 4
FIGURES & TABLES
Figure 1-1 Controller Display Illustration 5
Figure 2-1 Panel Opening Sizes and Installation 7
Figure 2-2 Noise Suppression 9
Figure 2-3 Noise Suppression 10
Figure 2-4 Wiring Label 13
Figure 2-5 AC Power 13
Figure 2-6 Thermocouple Input 14
Figure 2-7 RTD Input 14
Figure 2-8 Volt, mV, mADC Input 15
Figure 2-9A 24VDC Transmitter Power Supply 16
Figure 2-9B 24VDC Power Supply 16
Figure 2-10 Remote Setpoint Input 17
Figure 2-11 Remote Digital Communications 18
Figure 2-12 Relay Output 19
Figure 2-13 SSR Driver Output 20
Figure 2-14 mADC Output 21
Figure 2-15 Position Proportioning Output 21
Figure 4-1 Proportional Bandwidth effect on Output 39
Figure 4-2 Dual Proportional Outputs 40
Figure 4-3 Setpoint Ramp Rate Example 42
Figure 4-4 Re-transmission Example 43
Figure 4-5 Setpoint Re-transmission Example 43
Table 3-1 Enable Mode Configuration Procedures 24
Table 3-2 Program Mode Configuration Procedures 28
Table 3-3 Tune Mode Configuration Procedures 33
Table 5-1 Calibration Procedures 45
Table 5-2 Test Procedures and Description 49
FLOW CHARTS
Flow - Calibration 44
Flow - Enable Mode 25
Flow - Program Mode 26
Flow - Setpoint 42
Flow - Standby Mode 41
Flow - Test Mode 48
Flow - Tune Mode 32