Partner SP-1030 - Figure 2.6 SATA Configuration Sub-Menu; SATA Configuration

16 CHAPTER 2 BIOS SETUP
SATA Conguration
SATA Controller(s)
Use this item to enable or disable the on-chip SATA controller. The default setting is Enabled.
SATA Mode Selection
This item is used to congure SATA mode. The default setting is IDE.
Aggressive LPM Support
This item is used to enable aggressive LPM (link power management) support. The default setting is
Disabled.
SATA Controller Speed
This item is used to congure SATA controller speed.
SMART Self Test
This item is used to enable monitoring of hard disks that support the S.M.A.R.T. (Self-Monitoring And
Reporting Technology) feature, which can allow the hard disk to report, under some circumstances,
impending failures of the hard disk.
Figure 2.6 SATA
Conguration sub-menu