PAW FC3.10 - Finish with Protocol; Finish Without Protocol

5 Commissioning [specialist]
2021/03 99E13331xx-mub-en - V07 17
5.9 Finish with protocol
Saves the commissioning with creating a protocol. For this, an external memory (USB flash
drive) must be connected to the service interface / USB port. This interface can only be
accessed after removal of the front panel, see chapter 4.1.
5.10 Finish without protocol
Completes the commissioning without a further saving on an external USB flash drive.
The settings made during the commissioning can be changed at any time in the corresponding
submenus.
After the commissioning is completed, the controller is ready for use.
Parameters
Meaning
Adjustment range
Factory setting
Language Selects the menu language German, Polish,
English, French,
Spanish, Italian
German
Controller mode Sets the type of controller Single controller,
client, server 1,
server 2, server 3,
IO-module,
deactivated
Single controller
Date Sets the date - -
Time Sets the time - -
Auto. Daylight
saving time /
standard time
Activates the automatic
change to daylight saving
time /standard time
Yes, No Yes
Scan Modbus Identifies the modules - -
Nominal
temperature
Sets the hot water nominal
temperature
35 ... 75 °C 60 °C
Functions Submenu of the functions - -
Finish with protocol Saves with protocol - -
Finish without
protocol
Saves without protocol - -