16 Description of function
40 99E13331xx-mub-en - V07 2021/03
measuring range at the flow
rate sensor
μC error μC error On, Off Off
Time error Time not defined or lost On, Off Off
Comm error Communication error in the
cascade network
On, Off Off
Disinfection error Disinfection not successfully
completed
On, Off Off
16.7 Parallel relay
The function
parallel relay
makes it possible to switch an additional relay in case of an error. It is
possible to select what kind of incident causes the relay to be switched.
Example: The parallel relay R2 is chosen for the primary pump. Whenever the controller sends
a signal to the primary pump, the relay R2 is switched.
This can be useful to switch hydraulic paths on or off using a zone valve, for example.
Parallel relay Activates the function On, Off Off
Relay 1 Submenu to relay 1 - -
Inactivate Status of the relay On, Off On
Primary pump Connects in parallel to the
primary pump
On, Off Off
Circulation pump Connects in parallel to the
circulation pump
On, Off Off
Disinfection Connects in parallel to the
disinfection
On, Off Off
Disinfection error Connects in parallel if
disinfection was not
successful
On, Off Off
Relay 2 Submenu to relay 2 - -
Inactivate Status of the relay On, Off On
Primary pump Connects in parallel to the
primary pump
On, Off Off
Circulation pump Connects in parallel to the
circulation pump
On, Off Off
To Next Page
Loading...
