PAW FC3.10 - Synchronise Date;Time; Auto Daylight Saving Time; Commissioning; Software Update

10 General settings
2021/03 99E13331xx-mub-en - V07 25
10.4 Synchronise date/time
Activates/deactivates the synchronisation of date and time. The synchronisation is only possible
in connection with an internet module.
10.5 Auto daylight saving time
Activates/deactivates the automatic daylight saving time / standard time
When the controller is delivered, this item is activated.
10.6 Commissioning*
Opens the commissioning menu to go through the settings again.
*Settings only visible with installer code (see chapter "User code").
10.7 Software update
To update the firmware, a USB flash drive with the new software on it must be connected to the
USB port. After that, the update can be started via this menu item. This can take 2 minutes.
10.8 Display
The submenu contains all settings to adjust the display to your individual needs. Here you can
adjust parameters like luminosity, contrast and inversion of colours. In addition to that, you can
activate the screen lock. After activating the screen lock, the screen is locked after a determined
period and accessing the menu of the controller is only possible after entering the set PIN code.
Parameters
Meaning
Adjustment range
Factory setting
Language Selects the menu
language
German, Polish,
English, French,
Spanish, Italian
German
Date Sets the date - -
Time Sets the time - -
Synchronise date/time Synchronises the
date/time (Internet
module is required)
Yes, No No
Auto daylight saving
time
Activates the automatic
change to daylight
saving time /standard
time
Yes, No Yes
Commissioning* Submenu of the
commissioning
- -
Software update Starts updating - -