12 USB
2021/03 99E13331xx-mub-en - V07 27
12 USB
The controller has a service interface (USB port) for standard USB flash drives. To connect a
USB flash drive, first remove the EPP insulation around the controller. In a second step,
unscrew the screw in the lower area of the controller and remove the white front panel. The
USB port is at the right of the display at the side of the controller.
Danger of damage and malfunction!
Subsequent damage by using USB 3.x is possible.
Only use USB flash drives of the type 1.x or 2.x for this service interface.
The following functions can be carried out with a USB flash drive:
12.1 Eject memory
Safe removal of a USB flash drive from the system in order to avoid data loss before the data
are completely saved.
12.2 Load settings
If there are controller settings on the USB flash drive, you can export them to the controller in
the menu item
Load settings
. A message is displayed when the loading is completed. Then the
controller is restarted.
12.3 Save settings
This menu item allows to save the controller settings on the USB flash drive. During the saving
process, the message
Copying data
is displayed, after that
Copying completed
.
12.4 Save alarms history
This menu item allows to save the alarm history on the USB flash drive.
During the saving process, the message
Copying data
is displayed, after that
Copying
completed
.
12.5 Save parameters history
This menu item allows to save the parameter history on the USB flash drive. During the saving
process, the message
Copying data
is displayed, after that
Copying completed
.
To Next Page
Loading...
