7 Status
2021/03 99E13331xx-mub-en - V07 21
7 Status
STATUS
Measured/balance values
Reports
Service
Controller
The menu item
status
contains submenus which allow to
look through all measured/balance values, temperatures
and flow rates at the sensors, relay states, operating
times, heat quantity, tap performance as well as error
messages.
In addition, the current firmware is displayed at the item
Controller
.
7.1 Measured values
SENSORS 1/2
ACT. MIN: MAX:
Sensor S1 °C 79.4 78.9 80.6
Sensor S2 °C -- 0.0 0.0
Sensor S3 °C 157.1 156.7 158.8
Sensor S4 °C 9.8 8.2 13.4
This menu item contains the information of all current
measured values of the sensors, their minimum and
maximum measured values as well as the states of the
relays (R1, R2, R3).
The minimum and maximum measured values can be
reset by pressing the operating button
Confirm.
Relay 1 0D 07H 01M
Relay 2 0D 00H 00M
Relay 3 0D 00H 00M
Pump 1 0D 07H 00M
Pump 2 0D 00H 00M
The current operating times (
work times
), the cycles of
operation, the heat quantity and the tap performance (
volume
) are recorded and are displayed in the
corresponding submenus. One example is shown in the
illustration.
The heat quantity and the tap performance
(tap volume
) are shown in the following periods of
time:
• Current value
• Day
• Week
• Month
• Total
• Total since
You can reset the data of the periods of time via the
Confirm
button.
To Next Page
Loading...
