3 Mounting and installation [specialist]
2021/03 99E13331xx-mub-en - V07 9
3 Mounting and installation [specialist]
3.1 Installation of the controller
The following section describes only the installation of the controller.
Follow the instructions of each respective manufacturer when installing external components
(valves etc.)
Do not put the controller into operation in case of any visible damage.
1. temperature sensors
S1-S4 (Pt1000)
2. flow sensors
(VFS/US)
3. outputs PWM
4. modbus (RS 485)
5. RS 232
6. outputs 230 V
7. supply
8. position of the jumper
9. fuse
Risk of death by electrocution!
Disconnect the controller from the power supply before opening the
body.
Make sure that the power supply cannot be unintentionally switched on
when the body is open.
To Next Page
Loading...
