Fatigue Technology Inc. 401 Andover Park East Seattle, WA • USA 98188-2868 Tel: (206)246-2010 Fax: (206)244-9886
4 358856-REV K
SECTION 2.0: SAFETY
Consult PowerPak manual for safety precautions before connecting the puller unit.
When used in accordance with these instructions, the puller unit is safe and easy to use. All general safety precautions
associated with hydraulic and pneumatically operated power tools should be observed. Many of these are noted in
this section. Ultimately, the operator is responsible for personal safety; however, the following general safety
precautions should be observed.
CAUTION: The weight of this unit may require a suspension system per the end user’s workplace lifting
standards.
1. Operators must read this manual in its entirety before using the Medium Brute. Wear eye and hearing protection
when operating the puller unit. Do not strike any part of the tool with a hammer or equivalent object. Keep hands
and fingers clear of the nosecap, as they could be crushed between the nosecap and the workpiece. Safety labels
on the tool act as a reminder to these instructions and are shown in Figure 2.0-1.
Read manual before using Always wear eye protection Always wear hearing protection
Do not strike Keep fingers away from nosecap
Figure 2.0-1
Safety Labels
2.
This puller unit must be used with an FT-200D, FT-200C, or FT-20 PowerPak hydraulic pump. This manual
does not cover the use and safety precautions of these accessories. Refer to the PowerPak operator manual for the
specific pump being used.
To Next Page