Need help?Do you have a question about the Peak C-7100 Series and is the answer not in the manual?
General| Brand | Peak |
|---|---|
| Model | C-7100 Series |
| Category | Measuring Instruments |
| Language | English |
Guides users through the process of unpacking, checking, and installing the instrument correctly.
Performs a check of the wavelength calibration, potentially correcting it automatically.
Reads and checks the instrument's dark current for accuracy and applies correction.
Explains how to input and set the desired working wavelength for measurements.
Details how to create a standard curve by measuring known samples for concentration analysis.
Explains the process of measuring standard samples to build a calibration curve.
Describes how to measure a sample and obtain its concentration value using a standard curve.
Details setting parameters like time interval, test time, and measurement mode for kinetic scans.
Explains how to calculate the slope from kinetic scan data within a specified time range.
Guides on setting scan range, interval, test mode, and smoothing for wavelength scans.
Explains the importance and process of creating a system baseline before scanning.
Details how to establish a user-defined baseline by correcting with a reference sample.
Guides on setting the number of wavelengths and inputting specific wavelength values for testing.
Explains how to perform baseline correction for multiple wavelengths.
Explains selecting test modes and parameters for DNA and Protein analysis.
Lists common causes and solutions for power-related issues and boot failures.
Details failures during self-test related to positioning, signal detection, and component errors.
Provides step-by-step instructions for replacing the tungsten lamp.
Guides users through the process of replacing the deuterium lamp.
To Next Page
