Peak C-7100 Series User Manual

C-7100 Series User Manual PEAK INSTRUMENTS INC.
37
2. Self-test failure
Failures
Causes
Solutions
Loose electrical line filter
Opening the housing service personnel
under the guidance of re-seated
Optocoupler line filter loose
Opening the housing service personnel
under the guidance of re-seated
Filter
+12 V power supply board is not normal
Opening the housing service personnel
positioning
or loose cable
under the guidance of re-seated
error
Filter optocoupler bad
Please contact the manufacturer or your
local dealer
Motor driver chip on the motherboard
Please contact the manufacturer or your
bad TD62083
local dealer
Switching motor cable loose
Opening the housing service personnel
under the guidance of re-seated
Switch micro switch wire loose
Opening the housing service personnel
under the guidance of re-seated
Positioning
Switching bad micro switch
Opening the housing service personnel
error sources
under the guidance of re-seated
+12 V power supply board is not normal
Please contact the manufacturer or your
or loose cable
local dealer
Motor driver chip on the motherboard
Please contact the manufacturer or your
bad TD62083
local dealer
Motherboard connector cable loose signal
Opening the housing service personnel
board
under the guidance of re-seated
Power board + / -15 power cable is loose
Opening the housing service personnel
Error signal
or not properly
under the guidance of re-seated
detector
Bad signal board
Please contact the manufacturer or your
local dealer
Bad motherboard
Please contact the manufacturer or your
local dealer
3. Other failure
Failures
Causes
Solutions
Normal self tungsten
Tungsten lights over 2000 hours or
Refer to Chapter XV to replace
lamp wavelength
bad
tungsten lamp
region of low energy or
Use too long causes the internal
Please contact the manufacturer or
unstable
optics moldy
your local dealer
Experimental cuvette with a glass
Use quartz cuvette
Wavelength calibration
Both sides of the sample chamber
Lens cleaning paper moistened with
is too dirty lens
alcohol to wipe dry
test normal low energy
Deuterium lamp is lit more than
Refer to Chapter XV deuterium lamp
deuterium lamp or
2000 hours or bad
replacement
unstable areas
Use too long causes the internal
Please contact the manufacturer or
optics moldy
your local dealer

Peak C-7100 Series Specifications

General

Brand	Peak
Model	C-7100 Series
Category	Measuring Instruments
Language	English