User preferences
User preference allows you to customize time and LAN interface, press 【F4】to access selected
parameter preference menu, and 【F5】 to return to SETUP entry menu.
Date and time:
Chose Date and time, then press 【F4】to select and access the time setting interface, use the up/down
arrow keys to chose parameters, and the left/right arrow keys to set up each parameter, press 【F5】 to
confirm the selection and make the setting active.
LAN interface configuration:
Press up/down arrow keys to select eth0, then press 【F4】 to access to setting interface of LAN
interface, 【F1】Tab keys to switch configuration parameters. When DHCP or fixed IP is highlighted,
press 【ENTER】key radio button to select this option. Access to IP address with 【F1】 Tab key, then
press up/down keys to change figure, and left/right keys to move the cursor. Make the change active by
pressing 【F4】confirmation key, press 【F5】to cancel the change and return to previous menu.
Calibration interface
Press 【F3】 to access calibration interface which shows current firmware version, correct password is
requested for processing calibration, do not calibrate the Analyzer arbitrarily but have it calibrated by
specified institution or the manufacturer. Press 【F5】to return to setting interface.
-53-
To Next Page
Loading...
Need help?
General
