PENKO SGM700 - 5 Main Menu; Setpoints

SGM700 Digitizer
5. Main Menu
In the Main menu you can change the Setpoints, display the TAC code and
display the CAL code.
5.1 Setpoints.
The SGM700 has four outputs that can switch on/off on different levels.
These levels have to be filled in at the setpoint menu.
Press key 3 <2 sec. to go into the Main menu.
Press key 2 <2sec. to the setpoint change menu.
Press key 1 <2 sec. to select a diffrent setpoint (1-4). Press key 2 <2 sec. to
change the selected setpoint. Key 1 is used for changing the number (1-9), key 2
is used for changing the position of the cursor. Press key 3 >2sec. to confirm.
Up Down Left Right Confirm
When the selected setpoint is changed, the display changes to the next setpoint.
20