SGM700 Digitizer
First use of indicator -continue-
4.2 First use of indicator -Calibration-
Press key 3 for >2sec. to get in to Configuration Menu.
Go to the Calibration parameters by pressing key 1 <2 sec. until you see - - - CAL
x10
Check and delete calibration points.
To enter the Calibration settings, press key 2 <2 sec.
The following screen is visible:
Press key 1 <2 sec. to go to CAL 3 and press key 2 <2 sec.
Use CAL 3 to check and delete all existing calibration points. Step through the
calibration points with key 1. Delete a calibration point by pressing
key 3 >3 sec.
Up Down Delete
During deletions, the following screen is visible:
17
To Next Page
