SGM700 Digitizer
Configuration Menu -dSF- -continue-
The following screen is visible:
In dSF 2 you can set the Cutoff frequency. Determines the range used for
filtering the signal. Choose between oFF, 1.0Hz, 1.4Hz, 2.5Hz, 5.0Hz, 10.0Hz,
20.0Hz and 40Hz. Press key 2 <2 sec. to change the cutoff frequency range.
The following screen is visible:
Use key 1 change the cutoff frequency. Confirm by pressing key 3 for >2 sec.
Up Down Confirm
The following screen is visible:
In dSF 3 you can set the moving average cutoff frequency. Choose a value
between 0-320 Hz. Press key 2 <2 sec. to change the cutoff frequency range.
The following screen is visible:
53
To Next Page
Loading...
