SGM700 Digitizer
Configuration Menu -gCL- -continue-
Up Down Left Right Confirm
The following screen is visible:
In gcL 2 you can set the origin elevation of the loadcell. This is the geographic
elevation of where the loadcell is manufactured. Press key 2 <2 sec. to set the
origin elevation.
The following screen is visible:
Use key 1 and key 2 to enter the origin elavation of the loadcell(s). Key 1 is used
for changing the number (1-9), key 2 is used for changing the position of the
cursor. And press key 3 >2 sec.to set the origin elevation. Choose value
between –1000 and 30000 meter.
Up Down Left Right Confirm
The following screen is visible:
68
To Next Page
Loading...
