PenMount Touchscreen 6000 - Install Penmount Linux X Window RS-232 Driver and USB Driver; Calibration Utilities; Install Penmount Windows CE Driver

Chapter 3 Installing Drivers for 6000 Boards
29
Ubuntu
6.06 / 6.10 / 7.04 / 7.10 / 8.04 / 8.10 / 9.04 / 9.10 / 10.04 / 10.10 /
11.04 / 11.10 / 12.04 / 12.10
●
●
Debian 4.0 / 5.0 / 6.0
●
●
Debian 3.1
Fedora
4/5/6/7/89/10/11/12/13/14/15/16/17 32_64bit
●
●
Fedora Core3
●
Fedora Core2
●
Slackware12.0/12.1
●
●
Slackware10.0
Red Hat 9.0
●
Red Hat 7.3 / 8.0
●
●
OpenSuse
10.1/ 10.2/ 10.3/ 11/ 11.1/ 11.2/ 11.3/ 11.4/ 12.1 / 12.2
●
●
Suse 10.0
●
Suse 9.2/9.3
Suse 8.0/9.0/9.1
Cent OS 5.2/ 5.3/ 5.4/ 5.5/ 6.0/ 6.2 32_64bit
●
●
Linux XFree86 4.x.x
Linux XFree86 3.3.6
Linux For GPM
●
●
QNX 6.4.1/ 6.5
●
●
QNX 6.3.2
QNX 6.2
●
Android
●
●
3.3.1. Install PenMount Linux X Window RS-232 Driver and USB
Driver
See the readme file included in the driver folder.
3.3.2. Calibration Utilities
See the readme file included in the driver folder.
3.4. Install PenMount Windows CE Driver
Before installing PenMount WinCE Driver, you must have WinCE system installed and
running in your device. You must also have had either PenMount USB control boards
6200D, 6202B, 6300A or 6500A installed.
NOTE: Make sure you can move the WinCE cursor with a serial mouse attached to the
target COM port (e.g. COM2) before connecting the 6000 control board by
RS-232 port.
3.4.1. Install PenMount Windows CE Driver
Please see the readme file included in the driver folder.