3.2.1. Install PenMount Windows Universal Driver (for
2000/XP/2003/VISTA/7)
3.2.2. > 3.2.2.1. > Setting: Pen Input Emulation & Click on
Release are added to Operation Mode.
Chapter 2 > 2.3 > 2.3.2. Install A PenMount 6202B Control
Board: The picture of PenMount 6202x Control Boards Upside are
updated.
PenMount 6202 is changed to “6202x” in this manual.
To each PenMount 6200x, 6202x, 6300 and 6500 Control Boards,
mechanical diagrams are added. See sections 2.3.1, 2.3.2, 2.3.3,
and 2.3.4.
Chapter 2 > 2.2 Installation Diagrams: The installation diagrams
are revised for 6200x, 6202x, 6300, and 6500 boards.
PM6200X is changed to PM6200A on page 4 and to PM6200C on
page Error! Bookmark not defined..
PM6200X is changed to PM6200A or PM6200C and the pictures
and mechanical diagrams are updated for PM6200A and 6200C on
page 9, Error! Bookmark not defined., and 10.
PM6202X is changed to PM6202B and graphics are rearranged on
page 11, 11, and 12.
PM6300 graphics are changed on page Error! Bookmark not
defined..
PM6500 graphics are changed on page Error! Bookmark not
defined..
PM6202X is changed to PM6202B on page Error! Bookmark not
defined..
Refinement of section 3.2 starting from page 20.
Graphic of Windows XP 64bit tools is changed on page 39.
The original 3.2.5. PenMount Rotating Function is advanced
Error! Reference source not found. Error! Reference source not
found. on page Error! Bookmark not defined.. And “Vista 32/64bit”
is deleted from the description.
PM6202X is changed to PM6202B.
PenMount Linux X Window RS-232 and USB Drivers support
table is updated on page 28.
To the software function table in Chapter 4 Driver Software
Functions on page 30, VISTA/7 column and an additional remark
are added. In the same table, Stream/Point Mode is changed to
Operation Mode.