PenMount Touchscreen 6000 - Page 4

 The screenshots of PenMount Control Panel are updated on
page Error! Bookmark not defined..
 Error! Reference source not found. is added to PenMount Control
Panel functions on page Error! Bookmark not defined..
 4 points calibration is deleted from Advanced Calibration on page
Error! Bookmark not defined..
 “Vista 32/64bit” and “Windows 7 32/64bit” are deleted from the
description of 4.2 Multiple Monitors on page 33.
 All screenshots in section 4.2 Multiple Monitors are updated
starting from page 33.
 Screenshot of PenMount Control Panel’s Tools tab is updated on
page Error! Bookmark not defined..
 Section 4.5 is replaced by The Settings Tab
The Settings Tab is available for mouse devices, which user
can adjust operation modes, enable beep sound, and change
press and hold settings.
 Operation Mode on page 39.
 The screenshots of AP are updated on page 44.
 The screenshots of PenMount Control Panel and Gestture
Setting are updated on page 46.
 The screenshots of PenMount Gestures under Windows
XP/Vista/7 are updated on page 47.
 Screenshots of Gesture Setting and the description of General
Setting Box are updated on page 48.
 Icons of PenMount gestures are updated on page 49.
10/Sep/’12
1.7
 PM6200A and PM6200C are changed into PM6200D.
PM6300 is changed to PM6300A.
PM6500 is changed to PM6500A.
The correspondent pictures and mechanical diagrams are updated
on chapter 2.2 and 2.3.
 The updated drivers on chapter 1.3 and 3.3 support Windows 8,
WinCE 7.0 and new Linux system.
 The updated installation guide of PenMount Windows universal
driver is on chapter Error! Reference source not found..
20/Sep/’12
1.8
 Change screenshots to Windows 8
 Add descriptions on Setup.ini and Install.ini in 3.2.2
 Content of PenMount Universal Driver in Chapter 3 and Chapter 4
is re-organized.