PenMount Touchscreen 6000 - 3.2. Install PenMount Windows Universal Driver (for 2000;XP;2003;VISTA;7)

Installing Drivers for 6000 Boards
Section
Option
Value
Description
Install
USB
1
Install the PenMount USB driver.
0
Skip the PenMount USB driver installation.
COM
1
Install PenMount RS232 driver.
0
Skip the PenMount RS232 driver installation
MMonitor
1
Install PenMount for multiple monitor mapping
0
Disable the PenMount multiple monitor support
ENUM
1
Install PenMount non-PnP RS-232 device
detection
0
Disable PenMount non-PnP RS-232 device
detection
Option
TouchReport*
1
Install device as mouse device.
2
If system supports Tablet PC Input, install
device as digitizer device; if not, install as
mouse device
EdgeOffset
0
The value used by edge compensation
5
10
15
20
25
30
Smoothing
1
Enables line smoothing, might affect
performance
0
Disables line smoothing
Operation**
0
Touch operates in “Pen Input Emulation” mode
1
Touch operates in “Click on Touch” mode
2
Touch operates in “Mouse Emulation” mode
3
Touch operates in “Click on Release” mode
CalibOffset
---
Reserved, please do not change the value
RBtnPressNHold**
1
Enables press and hold for right button
0
Disables press and hold for right button
Serial
ScanAllPorts
1
Scans all available COM ports for detecting
PenMount RS-232 devices.
The detection on some systems might take a
few time to finish.
0
Do not scan ports
COMx
<mode>
,<baud>
Manually set up a PenMount non-PnP RS-232
on a specific COM port, operates in the baud
rate specified.
For example, “COM1=6000,19200” means
installing PenMount 6000 with 19200 bps on
COM1.
* The Windows XP Tablet PC Edition / Windows Vista / Windows 7 / Windows 8 supports
digitizer devices.
** These options will only work when installed as mouse device.
3.2.3. Device Driver Installation