Installer Manual 255-LOGIX 740-760 - Programming
Ref. MKT-IM-001 / C - 08.10.2019 43 / 76
6.4.2. Cycle time programming
Press and hold the and for 5 seconds when the controller is not in regeneration to enter
cycle time programming.
→ A small “C#” with a number will be displayed indicating the controller is in cycle time
programming.
→ The number indicates the cycle being viewed or changed.
→ Cycle times are programmable from 0 to 200 minutes.
* This parameter is calculated by the Logix controller. Therefore it can not be edited.
Note
See chapter 3.4. System regeneration cycle (8-cycles operation), page 17 for more
information about cycles.
C1-Backwash C5-Fast Rinse
C2*-Brine Draw C6-2nd Backwash
C3*-Slow Rinse C7-2nd Fast Rinse
C4-Re-pressurize C8*-Refill
To Next Page
Loading...
