Pentair Evolio 255 Series - Page 39

Installer manual Evolio 255 740-760 - Programming
Ref. MKT-IM-037 / D - 25.10.2021 39 / 90
9 "g/L" Indicates that the value entered/displayed is in grams/Liter.
10 "KG" Indicates that the value entered/displayed is in kilograms or kilograins,
depending on selected unit mode in P9, see Advanced programming
[
→
Page45].
11 "x100" x100 multiplier for large values.
12 "Lbs/ft3" Indicates that the value entered/displayed for regenerant amount is in
pounds per cubic foot.
13 Faucet Appears when the current flow rate is displayed.
The controller may show the faucet and "0", indicating no flow.
14 Maintenance
interval
Displayed when the duration in month since last maintenance exceed
the value programmed in parameter P11
15 Digits Four digits used to display the time, program value or error codes.
16 Number Used with #19, #21 and #22.
Displays a sequence number or value.
17 History values (H) The number displayed by #18 identifies which history value is currently
displayed.
18 Parameter (P) Displayed only in advanced programming.
The number displayed by #18 identifies which parameter is currently
displayed.
19 Cycle (C) The number displayed by #18 is the current cycle in the regeneration
sequence.
20 "x2" Indicates a second regeneration has been called for.
21 Hardness Hardness setting in mg/L as CaCO
3
or ppm.
22 Capacity Shows estimated system capacity.
23 Regen icon Flashes when a regeneration at the next time of regeneration has been
called for.
Also displayed (continuously) when in regeneration.
24 Salt setting Programming the amount of salt used for a regeneration.
25 Regeneration time Programming the time of regeneration.
26 Time of day Programming the current time of day.