Pentair Evolio 255 Series - 7 Operation; Display; During Operation; During Regeneration

Installer manual Evolio 255 740-760 - Operation
54 / 90 Ref. MKT-IM-037 / D - 25.10.2021
7 Operation
7.1 Display
7.1.1 During operation
Depending of the clock mode programmed, display shows:
• P10=0, current time in 12 am/pm alternating with remaining capacity in US gallons;
• P10=1, current time in 24 hours alternating with remaining capacity in cubic meters.
• The current time in 24 hours is displayed:
• The remaining capacity (in m
3
) is displayed:
7.1.2 During regeneration
• A "C#" is displayed to show the current cycle;
• total regen time remaining in minute is displayed on
screen;
• you can press and hold to show current cycle time
remaining.
7.2 Manual regeneration
Mandatory
The controller must be in service in order to enable this procedure.
Info
The unit returns to normal operation if no buttons are pressed within 30 seconds.
7.2.1 Manual delayed regeneration
1. Press once for delayed regeneration.
ð The regeneration will start on the scheduled time. See chapter 5.1. Display, page 39.
ð A flashing regen symbol will be displayed.