Pentair STA-RITE SC-75P - Page 131

7
English
Connecng AC Power to the Power Center using an Automac Timer
Connect AC power using an automac mer to the power center as follows:
1. IMPORTANT WARNING: Be sure that the Power Center AC power line is switched OFF before connecng AC power to
the Power Center.
2. Use 12-14 AWG three conductor insulated wire for the main AC power connecon. Connect the Power Center to pool
pump AC power source. The Power Center should be connected to the pump motor switch or automac mer.
3. Aach incoming GROUND wire to the terminal block inside the Power Center (Green/Yellow wire). Connect Blue wire
to Neutral and Brown wire to Phase
5. Reinstall the Power Center cover and secure with the cover screw.
6. The Power Center installaon is complete. For SC-75 operang informaon, refer to the SC-75 User’s Guide.
Aach incoming power
wires from load center-
lter pump relay
(12-14 AWG 3wire) to
SC-75 Power Center AC
power wires
Conduit (PG Nut) for AC
power cable source
SC-75 Power Center (cover removed)