Pentair SunTouch - Schedules Menu (4;14)

17
SunTouch
®
Control System Installation and User’s Guide
Schedules Menu (4/14)
Scheduled start and stop programs can be assigned to pool, spa and auxiliary circuits (AUX 1, AUX 2,
AUX 3) and FEATURE 1 - 4 functions. The start and stop times can be programed to run automatically
within a 12 hour period. The default run time for a scheduled circuit is 8:00 AM to 5:00 PM which can be
adjusted in 15 minutes increments. A maximum of four scheduled programs can be setup for any one circuit,
with a total of six programs for all circuits combined.
To program a circuit:
Add a new program to a circuit
Press the Menu > Right arrow buttons to select the Schedules menu (4 of 14).
Press the Right button to access the schedule settings and program an available
circuit.
Press the Up/Down arrow buttons to select the circuit to program. The circuits
are: POOL, SPA, AUX 1, AUX 2, AUX 3, FT 1 - FT 4. If there existing programs
assigned to circuits, use the Up/Down arrow buttons to scroll through the each
programmed circuit.
Press the Right arrow button twice to select the mode settings (Add, Edit Delete).
To add a program, Use the Up/Down button to select Add. Press the Right arrow
button. Edit is displayed (blinks on and off) and the circuit number will increment
from zero to one (1/1). At this point there are still three available circuit that can be
assigned to that circuit.
Mode settings
• Add: Add up to four programs to the selected circuit.
• Delete: Delete the current program
• Edit: Move to the Start/Stop time for the current circuit program.
Set the start and stop time
Press the Right arrow button to set the START time setting for the circuit.
Press the Up/Down arrow button to set the START time to automatically start the
circuit. Adjust the start time in 15 minutes increments for AM or PM.
Press the Right arrow button to move to STOP time setting.
Press the Up/Down button to set the time to automatically stop the circuit. Adjust the
stop time in 15 minutes increments for AM or PM.
Press the Right button twice to set or edit another program
(e.g. AUX 1-3 or FT. 1 - 4).
or
Press the Left button to return to the main status screen.
Main Menu 4/14
Schedules
Schedule [Pool ]
Prg: 0/0 - Add
Schedule [Pool ]
Start: 8:00 AM
Schedule [Pool ]
Stop: 5:00 PM
Schedule [Pool ]
Prg: 2/1 - Edit
Schedule [Pool ]
Prg: 1/1 - Add
Main Menu 4/14
Schedules
Schedule [FT. 1 ]
Prg: 1/0 - Edit
POOL 71°F / 91°F
11: 51AM HEATER
Schedule [FT. 1 ]
Prg: 0/0 - Add